Getting closer to the BIG day!
The crank case sensor is now all fitted 🙂
Continue readingMonthly Archives
The crank case sensor is now all fitted 🙂
Continue readingSo its finally got to the point where i am getting ready for the big day!! The fuel system works, im just finishing the crank sensor install, which will mean i can then start to add oil to the engine and then water. I also need to finish the coil mounting bracket and and fit the ECU and then a good check over things to make sure they are all secured and tight and we will be ready for a test start! As Christmas is not far off now i think its going to be the new year before im…
Continue readingFinally got round to giving the fuel system a test! and apart from a small leak from one of the fuel filter banjos (i think its missing a sealing washer) it worked like a charm 😉 much quieter than the old low pressure pump and runs back on the return fine! i just need to sort the breather pipes back up to the filler neck now and fit that washer and we are done. #happydays
Continue readingFound this little gem on ebay in germany. Its 2mm out on the offset but as they are like rocking horse … I thought it would be nice as an extra spare!!
Continue readingThe exhaust is now fully fitted 🙂 and i have started to fill the fuel tank up ready for the big day!!
Continue reading